Aeg-Electrolux 64500G-M Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Sporáky Aeg-Electrolux 64500G-M. Aeg-Electrolux 64500G-M User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk

Shrnutí obsahu

Strany 1 - 64500G-M

64500G-Minstruction booklet gas hobIEGB

Strany 2

10The pan supportsTo ensure a better cleaning, pan supportscan be removed from the hob.Wash the pan supports using hot soapy water.If necessary, a pas

Strany 3 - Contents

11Something Not Working?If the hob is not working correctly, please carry out the following checks before contactingyour local Service Force Centre.

Strany 4 - Important safety information

12OVERALL DIMENSIONS Width: 594 mmDepth: 510 mmCUT OUT DIMENSIONS Width: 560 mmDepth: 480 mmSUPPLY CONNECTIONS Gas:R 1/2 inch (1/2 inch male) Rear rig

Strany 5 - Environmental Information

13Gas burnersBURNER RAPID SEMI-RAPIDAUXILIARYPOSITION MAX MIN MAX MIN MAX MIN NOMINAL THERMAL POWER kW 3.0 0.75 2.0 0.45 1.0 0.33 NOMINAL FLO

Strany 6 - Description of the hob

14Important Safety RequirementsThis hob must be installed in accordance with the Gas Safety (Installation and Use)Regulations (Current Edition) and th

Strany 7 - Operation

15IMPORTANTAny gas installation must be carried out by a GAS SAFE REGISTER installer.Please, ensure that, once the hob isinstalled, it is easily acces

Strany 8

16LocationThe hob may be located in a kitchen, akitchen/diner or bed sitting room, but notin a bathroom, shower room or garage.Ensure that there is a

Strany 9 - Mainteinance and Cleaning

17Fitting the Hob into the WorktopCarry out the building in of the hob as follows:1) place the seals supplied with thehob on the front edge of the cu

Strany 10 - The pan supports

182Dimensions are given in mm.3Building over a cupboard or drawerIf the hob is to be installed above a cupboard or drawer it will be necessary to fit

Strany 11 - Something Not Working?

19Electrical ConnectionsAny electrical work required to install this hob should be carried out by a qualifiedelectrician or competent person, in accor

Strany 12 - Technical data

2Thank you for choosing one of our high-quality products.To ensure optimal and regular performance of your appliance please read thisinstructionmanual

Strany 13 - Gas burners

20Permanent ConnectionIn the case of a permanent connection, it is necessary that you install a double pole switchbetween the hob and the electricity

Strany 14 - Important Safety Requirements

21Fault FindingPreliminary Electrical Systems CheckSTARTIsolate applianceand carry out:A: Earth Continuitycheck. Has inlet fuse blown?Carry out:C: Pol

Strany 15 - Gas Connection

22A. EARTH CONTINUITY CHECKAppliance must be electrically disconnected - meter set on W (Ohms) x 1 scale and adjustzero if necessary.— Test leads from

Strany 16 - Location

23Check gas supply atburnerIgnition System / Gas IgnitionYESCheck plug top fuse andreplace if necessaryCheck polarity and earthcontinuity of supply po

Strany 17

24CommissioningWhen the hob has been fully installed it will be necessary to check the minimumflame setting. To do this, follow the procedure below.1)

Strany 18 - Building In

25IMPORTANTThe replacement/conversion from natural gas to LPG should only be undertakenby a competent person.It is important to note that this model i

Strany 21 - Fault Finding

39713-7301 07/09 R.A Subject to change without noticewww.aeg-electrolux.co.uk

Strany 22 - B. INSULATION CHECK

3Important Safety Information... 4Descriptio

Strany 23

4Installation• This appliance must be installed andserviced by a competent person as statedin the Gas Safety (Installation and Use)Regulations Current

Strany 24 - Pressure Testing

5cause an accident by tipping or spillage.• Never leave the hob unattended whencooking with oil and fats.• Never use plastic or aluminium foil disheso

Strany 25 - TO ADJUST THE GAS RATE

6Description of the hobINSTALLATIONAny gas installation must be carried out by a registered competent person,and in accordance with existing rules and

Strany 26

7OperationHob burner control knobsThe symbols on the knobs mean:  = no gas supply = maximum gas supply = minimum gas supplyFor easier li

Strany 27

8Once the hob has been installed, it is important to remove any protective materials,which were put on in the factory.As soon as a liquid starts boili

Strany 28

9Mainteinance and CleaningThe Hob Top Regularly wipe over the hob top using a soft cloth well wrung out in warm water towhich a little wasing up liqu

Komentáře k této Příručce

Žádné komentáře