Aeg-Electrolux 65852G-M Uživatelský manuál

GB IE 65852G-MUser manual Gas hob

min 20 mm(max 150 mm)30 mm60 mmbaa) Removable panelb) Space for connectionsKitchen unit with ovenThe hob recess dimensions must obey the indication an

Control knobsSymbol Descriptionno gas supply / off positionignition position / maximum gas supplyminimum gas supplyOPERATIONIgnition of the burnerWARN

12341 Burner cap2 Burner crown3 Ignition candle4 ThermocoupleWARNING!If the burner does not light after 15 seconds, release the control knob, turn it

WARNING!Always turn the flame down or switch it off before you remove the pans of the burner.HELPFUL HINTS AND TIPSEnergy savings• If possible, always

WARNING!Do not use abrasive cleaners, steel wool pads or acids, they can cause damage to the appli-ance.• You can remove the pan supports to easily cl

WHAT TO DO IF…Problem Possible cause RemedyThere is no spark when lightingthe gas• There is no electrical supply • Make sure that the unit isconnected

MOD.PROD.NO.SER.NODATAMOD.PROD.NO.SER.NODATAMODELMODELMOD.PROD.NO.SER.NO.03 ITMADE IN ITALYTYPE230V-50HzIP2000491 2 31 Stick it on Guarantee Card an

Electric supply: 230 V ~ 50 Hz3 core flexible cable with non rewireable plugfitted with a 3 amp cartridge fuseGas connection: R 1/2 "Category: II

Packaging materialThe packaging materials are friendly to the environment and can be recycled. The plasticcomponents are identified by marking: >PE

19

Thank you for choosing one of our high-quality products.To ensure optimal and regular performance of your appliance please read thisinstruction manual

www.aeg-electrolux.com/shop 397175001-A-452010

Child safety• Only adults can use this appliance. Children must get supervision to make sure that theydo not play with the appliance.• Keep all packag

• Only use built-in appliances after you assemble the appliance into correct built-in unitsand work surfaces that obey the standards.• Do not install

• If the fixing bracket is near to the terminal block, always make sure the connection cabledoes not come in contact with the edge of the bracket.• Yo

Gas ConnectionWARNING!Any gas installation must be carried out by a GAS SAFE REGISTER installer.Make sure that, once the hob is installed, it is easil

3. With a socket spanner 7 remove the injectors and replace them with the ones whichare necessary for the type of gas you use (see table in Technical

Electrical RequirementsAny permanent electrical installation must comply with the latest I.E.E. Regulations and lo-cal Electricity Board regulations.

Upon completion there must be no cut, or stray strands of wire present and the cord clampmust be secure over the outer sheath.A cut off plug inserted