Aeg-Electrolux 75857G-B Uživatelský manuál

75857G-Binstruction booklet gas hobIEGB

10YESNOThe pan supportsTo ensure a better cleaning, pan supportscan be removed from the hob. To keep thepan supports in the correct position, theyare

11Something Not Working?If the hob is not working correctly, please carry out the following checks before contactingyour local Service Force Centre.

12OVERALL DIMENSIONS Width: 680 mmDepth: 510 mmCUT OUT DIMENSIONS Width: 560 mmDepth: 480 mmSUPPLY CONNECTIONS Gas:R 1/2 inch (1/2 inch male) Rear rig

13Gas burnersNATURAL GAS20 mbarVALUE =37.78 MJ/m3Ws - 50.7 MJ/ m3TYPE OF GASLPG GAS28-30/37 mbarVALUE =49.92 MJ/KgBURNER SEMI-RAPID AUXILIARY TRIPLECR

14Important Safety RequirementsThis hob must be installed in accordance with the Gas Safety (Installation and Use)Regulations (Current Edition) and th

15IMPORTANTAny gas installation must be carried out by a GAS SAFE REGISTER installer.Please, ensure that, once the hob isinstalled, it is easily acces

16LocationThe hob may be located in a kitchen, akitchen/diner or bed sitting room, but notin a bathroom, shower room or garage.Ensure that there is a

17Fitting the Hob into the WorktopCarry out the building in of the hob as follows:1) Remove the pan supports, the burners caps andcrowns and turn the

182Dimensions are given in mm.3Building over a cupboard or drawerIf the hob is to be installed above a cupboard or drawer it will be necessary to fit

19Electrical ConnectionsAny electrical work required to install this hob should be carried out by a qualifiedelectrician or competent person, in accor

2Thank you for choosing one of our high-quality products.To ensure optimal and regular performance of your appliance please read thisinstructionmanual

20Permanent ConnectionIn the case of a permanent connection, it is necessary that you install a double pole switchbetween the hob and the electricity

21Fault FindingPreliminary Electrical Systems CheckSTARTIsolate applianceand carry out:A: Earth Continuitycheck. Has inlet fuse blown?Carry out:C: Pol

22A. EARTH CONTINUITY CHECKAppliance must be electrically disconnected - meter set on W (Ohms) x 1 scale and adjustzero if necessary.— Test leads from

23Check gas supply atburnerIgnition System / Gas IgnitionYESCheck plug top fuse andreplace if necessaryCheck polarity and earthcontinuity of supply po

24CommissioningWhen the hob has been fully installed it will be necessary to check the minimumflame setting. To do this, follow the procedure below.1)

25IMPORTANTThe replacement/conversion from natural gas to LPG should only be undertakenby a competent person.It is important to note that this model i

26

27

39712-7801 04/09 R.A Subject to change without noticewww.aeg-electrolux.co.uk

3Important Safety Information... 4Descriptio

4Installation• This appliance must be installed andserviced by a competent person as statedin the Gas Safety (Installation and Use)Regulations Current

5cause an accident by tipping or spillage.• Never leave the hob unattended whencooking with oil and fats.• Never use plastic or aluminium foil disheso

6Description of the hobINSTALLATIONAny gas installation must be carried out by a registered competent person,and in accordance with existing rules and

7OperationHob burner control knobsThe symbols on the knobs mean:= no gas supply = maximum gas supply = minimum gas supplyFor easier lighting

8Once the hob has been installed, it is important to remove any protective materials,which were put on in the factory.As soon as a liquid starts boili

9Mainteinance and CleaningThe Hob Topz Regularly wipe over the hob top using a soft cloth well wrung out in warm water towhich a little wasing up liqu